PINTO CAR CLUB of AMERICA

Welcome to FordPinto.com, The home of the PCCA => General Help- Ask the Experts... => Topic started by: amxtra on August 20, 2012, 10:03:19 PM

Title: Swap V6 to 2.3
Post by: amxtra on August 20, 2012, 10:03:19 PM

  I looked at a few posts, would it correct that to go from a V6 to a 2.3 all I have to use is pinto 2.3 engine mounts? The crossmember and
stools are the same?  I did find that the bellhousing is different too, this is not an issue.
   Thanks

Title: Re: Swap V6 to 2.3
Post by: Pinto5.0 on August 21, 2012, 05:11:02 PM

I'm unsure if the throttle cable is long enough & the V6 radiator has the outlets in the wrong place.