PINTO CAR CLUB of AMERICA

Welcome to FordPinto.com, The home of the PCCA => General Help- Ask the Experts... => Topic started by: Jdm071755 on March 18, 2018, 11:03:37 AM

Title: Steering Column
Post by: Jdm071755 on March 18, 2018, 11:03:37 AM
Just replaced my rag joint  after putting it back together it seem the steering column needs to be adjusted down. I checked my manual but it was vague.  Anyone adjuster one? This is on an 80 cruising wagon.
Thanks


Sent from my iPhone using Tapatalk
Title: Re: Steering Column
Post by: Pintosopher on March 18, 2018, 04:22:25 PM
Is the Column too short, or is there a misalignment?
Title: Re: Steering Column
Post by: Jdm071755 on March 18, 2018, 04:25:01 PM
Is the Column too short, or is there a misalignment?
Just seems a Little short


Sent from my iPhone using Tapatalk
Title: Re: Steering Column
Post by: Pintosopher on March 18, 2018, 04:29:18 PM
Unless the Column safety Collapse feature was disturbed, or the rack was removed, all should be lined up and within the measured specs. Is there excess play in the rack pinion shaft?
Title: Re: Steering Column
Post by: Jdm071755 on March 22, 2018, 08:24:21 AM
Unless the Column safety Collapse feature was disturbed, or the rack was removed, all should be lined up and within the measured specs. Is there excess play in the rack pinion shaft?
Everything went together fine. Problem is that the rag joint is not  laying flat. The manual says if this occurs to pry up or down the column to correct this


Sent from my iPhone using Tapatalk
Title: Re: Steering Column
Post by: TIGGER on April 05, 2018, 02:10:44 PM
The end of the column where the rag joint connects can move in or out of the column.  You might have to extend it out some to make up for the difference.  good luck to you.