Current Classifieds

Offenhauser 6114 dp
Date: 09/12/2017 10:26 pm
Bell housing
Date: 08/23/2017 05:41 am
Pinto interior parts for Cruisen / Rallye wagon
Date: 01/19/2021 03:56 pm
t-5 2.3 trans and new flywheel cluch and pressure plate though out bearing for sale
Date: 09/09/2018 03:22 pm
Many Parts Listed Below
Date: 04/20/2018 11:15 am
1978 Squire wagon 6 Cly
Date: 03/08/2021 10:44 am
C-3 automatic transmission

Date: 08/17/2022 10:18 am
t-5 2.3 trans and new flywheel cluch and pressure plate though out bearing for sale
Date: 09/09/2018 03:22 pm
1970-1973 British 4 Speed Manual; Parts or Whole
Date: 03/17/2019 03:57 am
1977 Pinto for parts

Date: 10/10/2018 06:25 pm
1972 Runabout (GOING TO SCRAP BY 5/28)

Date: 05/21/2019 11:50 am
78 pinto wagon

Date: 06/04/2020 12:42 pm

« previous next »
Pages: [1]   Go Down

Author Topic: Shorten the FOG 4sp output?  (Read 1008 times)

0 Members and 1 Guest are viewing this topic.

Offline mr.mindless

  • Pinto Driver
  • *
  • Posts: 1
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Apple User
Shorten the FOG 4sp output?
« on: December 24, 2015, 01:47:58 PM »
I recently picked up a '74 2300 motor and trans for a microtruck re-power project. The motor is taller than I'd like, but I think I can deal with that - what has me completely stopped on using this donor is the enormously long output shaft on that FOG 4 speed. I've found nothing at all on anyone else wanting to shorten that output, nor have I been able to find much on transmission overall lengths.

I need to loose about a foot at bare minimum.

Anyone have an exploded diagram of the FOG?
Thoughts on a shorter transmission?
Experience hacking a foot of the output housing, shift rods, and mainshaft, and re-splining, drilling, and tapping it for a bolt on yoke? Hah.

Thanks,
Logged

Offline pinto_one

  • Pinto Master
  • *****
  • Posts: 1008
  • FeedBack: +70/-0
  • Gender: Male
  • Pinto-One

    • Total Badges: 10
    Badges: (View All)
    1000 Posts Photographer Tenth year Anniversary Topic Starter Signature Poll Voter Mobile User Apple User Windows User Fifth year Anniversary
Re: Shorten the FOG 4sp output?
« Reply #1 on: December 24, 2015, 04:10:28 PM »
If you have to knock a foot off of the trans you might as well use a different transmission, the trans you have now has the shifter built into the tail shaft , what you can do is buy the adaptor to use a old jeep transmission, the 2.3 was a good engine swap into the jeep back then, might want to check out a place called transdapet , they might still be around, hope this helps

Logged
76 Pinto sedan V6 , 79 pinto cruiser wagon V6 soon to be diesel or 4.0
Pages: [1]   Go Up
« previous next »