14 Guests, 0 Users

Author Topic: 78 Pinto rear axle modification  (Read 1192 times)

0 Members and 1 Guest are viewing this topic.

Offline 1olfrdanut

  • Pinto Driver
  • *
  • Posts: 2
  • FeedBack: +0/-0
  • Another Pinto Driver

  • Total Badges: 1
    Badges: (View All)
    Topic Starter
78 Pinto rear axle modification
« on: August 08, 2013, 02:40:45 PM »
I am installing a complete 1978 Pinto power train in my 31 Model A pickup.  To do so will require narrowing the rear axle housing by 2.25"  (1.625" on each end) and shortening the splined end of each axle shaft by the same amount.  As a matter of choice, I prefer to modify the superior Pinto rear end as opposed to altering the noisy old Model A banjo axle.  I don't want to disturb the perfectly operating Pinto differential and carrier assembly, by dissembling the unit to measure the length of the spider gear splines. Can anyone provide me with the spline design dimensions for this 1.625'x28 assembly?   I have professional machining and welding capability to make the mods, but don't want to assume anything about these modifications without first doing do-diligent research. 
Thank you, in advance, for any assistance you can provide. 1olfrdanut 

Offline amc49

  • PCCA VIP
  • Pinto Master
  • ***
  • Posts: 1256
  • FeedBack: +242/-1
  • Another Pinto Driver

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Poll Voter Windows User 1000 Posts
Re: 78 Pinto rear axle modification
« Reply #1 on: September 11, 2013, 02:50:00 PM »
FYI, you have to pull axles to re-machine the ends anyway, you do not have to disassemble the center section to simply remove a side spider gear to measure how thick it is. An open rear, the gear comes right out with axle out. No need to disturb the ring and pinion at all there.