Current Classifieds

Rear Bumper
Date: 07/26/2021 01:08 pm
v8 springs
Date: 05/07/2017 04:46 pm
Front Body parts needed
Date: 02/09/2018 06:09 pm
Built 2.0
Date: 10/07/2018 05:27 pm
Seeking parts
Date: 10/18/2020 10:35 am
'79 4 speed manual shifter needed
Date: 07/30/2018 04:32 pm
Front sump oil pan
Date: 01/02/2017 06:54 pm
Need right door for pinto or bobcat 1977 to 1980 station wagon
Date: 08/03/2018 09:19 am
Wanted - 71-73 Pinto grill
Date: 12/15/2016 03:32 pm
1974 Pinto Passenger side door glass and door parts

Date: 02/28/2018 09:18 am
Bellhousing for C4 to 2.0 litre pinto
Date: 01/30/2017 01:48 pm
Many Parts Listed Below
Date: 04/20/2018 11:15 am

« previous next »
Pages: [1]   Go Down

Author Topic: Point Gap and Fuel pume pressure  (Read 813 times)

0 Members and 1 Guest are viewing this topic.

Offline dennisofaz

  • Pinto Member
  • **
  • Posts: 98
  • FeedBack: +25/-0

    • Total Badges: 5
    Badges: (View All)
    Topic Starter Tenth year Anniversary Poll Voter Windows User Fifth year Anniversary
Point Gap and Fuel pume pressure
« on: February 28, 2018, 11:52:11 AM »
Hi, I have a 74 Runabout with a 2.3 and I need to know what the point gap souuld be, and what the fuel pump pressure should be.  Thank you in advance!


Dennis




Logged

Offline nnn0wqk

  • Pinto Member
  • **
  • Posts: 99
  • FeedBack: +24/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 5
    Badges: (View All)
    Topic Starter Poll Voter Windows User Tenth year Anniversary Fifth year Anniversary
Re: Point Gap and Fuel pume pressure
« Reply #1 on: February 28, 2018, 02:36:31 PM »
Point gap is .027 with dwell reading of 35-41 degrees. Timing is 6 degrees BTDC vacuum hose disconnected at distributor. Idle 850 rpm standard 750 auto in Drive. Plugs AGRF-52 gap is .034. Fuel pump pressure between 3.5-4.5 lbs and volume would probably run around a pint in 20 seconds. Total timing advance should approach 47 degrees.  Base 6 degrees, centrifugal advance 32 degrees, vacuum 4.3 degrees. You should see total centrifugal at 4700 rpm. I pulled all this information out of a 1974 Motor auto repair manual. A little more information than you asked for but since I had the book open thought I might as well list it for you.
Logged

Offline dennisofaz

  • Pinto Member
  • **
  • Posts: 98
  • FeedBack: +25/-0

    • Total Badges: 5
    Badges: (View All)
    Topic Starter Tenth year Anniversary Poll Voter Windows User Fifth year Anniversary
Re: Point Gap and Fuel pume pressure
« Reply #2 on: February 28, 2018, 03:35:55 PM »
Hi nnn0wqk, Thank you very much for the information!  I will try a 4-7lb electric fuel pump and see how it goes!


Dennis 
Logged
Pages: [1]   Go Up
« previous next »