Current Classifieds

Squire trim
Date: 03/28/2018 10:11 am
1975 Pinto bumpers
Date: 01/20/2018 07:51 pm
Ford 2.3L new gaskets for sale
Date: 12/10/2016 04:11 pm
Front sump oil pan
Date: 01/02/2017 06:54 pm
Need Interior Panels
Date: 07/09/2018 04:59 pm
Need 72 pinto parts!
Date: 06/14/2019 01:40 pm
convert to stick
Date: 05/19/2018 09:26 pm
'71,'72,or'73 small Ford v8 Pinto
Date: 01/23/2017 07:41 am
1980 Pinto Pony for sale

Date: 08/21/2021 03:54 pm
1980 Pinto Parts

Date: 08/05/2020 04:20 pm
1977 Left Side quarter panel
Date: 06/10/2019 04:16 pm
1974 Pinto Door Handles

Date: 03/07/2017 04:06 pm

Author Topic: Pinto won't rev , what should I do next?  (Read 901 times)

0 Members and 1 Guest are viewing this topic.

Offline sethvincent

  • Pinto Member
  • **
  • Posts: 12
  • FeedBack: +0/-0

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Tenth year Anniversary Windows User Fifth year Anniversary
Pinto won't rev , what should I do next?
« on: October 27, 2015, 01:51:24 AM »
I have a 78 that I've had a lot of problems with in the last couple months.  I'm going to list all the problems in case they are related.
The engine seemed to run hot, and after driving for a while, if you shut it down and didn't wait for it to cool down, it would start back up but would die within a minute and then it wouldn't start again until it sat for an hour or so.  When this happened I would get no fuel to the carb.  I couldn't get a mechanical pump right away so I threw in an electric pump that had similar specs to the factory pump.
 After changing the pump, I drove the car for a while, let is sit for about 10 minutes, tried to restart it and it wouldn't. Ran the battery down trying to start it.  Couple hours later, jump started it, drove home with no trouble.  Next time I went to drive it, battery was dead.  Put a new battery in, drove it about a half hour no problems. Couple hours later, drove home, again, no problem.
  Sat for two weeks, was really hard to start and when it finally did start, it wouldn't accelerate.
So, I replaced distributor cap, rotor, plugs, plug wires, timing belt and rebuilt the carb.  It stars very easily, but still doesn't accelerate.  I wanted to see if the advance was working and tried to rev it while using the timing light and noticed that when I tried to rev the engine, the light would go off, then come back on after I backed out of the throttle.
   Is this an ignition module issue?  coil?  distributor? something else entirely?