133 Guests, 1 User
caravan3921

Author Topic: TRANSMISSION CROSS MEMBER  (Read 1283 times)

0 Members and 1 Guest are viewing this topic.

Offline bbobcat75

  • Pinto Master
  • *****
  • Posts: 1032
  • FeedBack: +71/-0
  • Gender: Male

  • Total Badges: 8
    Badges: (View All)
    Topic Starter Signature Poll Voter 1000 Posts Apple User Mobile User Windows User Fifth year Anniversary
TRANSMISSION CROSS MEMBER
« on: March 17, 2014, 11:11:26 AM »
IS THERE A DIFFERNCE IN A AUTO TO MANUAL TRANS CROSS MEMBER??


THANKS
1975 mercury bobcat 2.8 auto
1978 mercury bobcat wagon 2.3l - soon to have a 88 tc drive line
1975 ford pinto - drag car - 2.3l w/t5 trans - project car

Offline Wittsend

  • Pinto Master
  • *****
  • Posts: 2067
  • FeedBack: +239/-0

  • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter 1000 Posts Linux User Windows User Fifth year Anniversary
Re: TRANSMISSION CROSS MEMBER
« Reply #1 on: March 17, 2014, 01:02:01 PM »
Well..., probably not applicable but "No," - if your going from a C-4 to a T-5 (in a '73). You simply reverse the crossmember and slot a few holes.  I even reused the old mount from the C-4 onto the T-5.  And I'm not even sure if the hole slotting was necessary.  I might have only done that "just in case."

Offline amc49

  • PCCA VIP
  • Pinto Master
  • ***
  • Posts: 1256
  • FeedBack: +242/-1
  • Another Pinto Driver

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Poll Voter Windows User 1000 Posts
Re: TRANSMISSION CROSS MEMBER
« Reply #2 on: March 18, 2014, 06:36:00 AM »
On '80 I changed mount only going from standard 4 speed to ATX. Crossmember stayed the same.