Current Classifieds

1980 Pinto taillights
Date: 12/26/2017 03:48 pm
Misc pinto parts 71-73 2.0
Date: 05/05/2020 11:56 pm
Chilton's Repair & Tune-up Guide 1971-1979 Pinto and Bobcat

Date: 03/06/2017 01:24 am
Parts Parts Parts
Date: 09/08/2018 03:13 pm
1974 Pinto Misc. moldings & parts

Date: 12/20/2016 10:47 pm
sport steering wheeel
Date: 10/01/2020 10:58 pm
Various parts for 1980 Pony (good to N.O.S. condition
Date: 06/07/2018 01:45 am
Wanted 1973 Ford right fender
Date: 06/03/2017 08:50 pm
1974 Wiring diagram free
Date: 10/27/2019 06:56 pm
Odds and Ends 1976-77 Pinto Wagon

Date: 07/17/2019 05:23 pm
Need right door for pinto or bobcat 1977 to 1980 station wagon
Date: 08/03/2018 09:19 am
1974 Pinto Right Rear Interior Trim Panel

Date: 02/18/2017 04:44 pm

Author Topic: passenger door light  (Read 1410 times)

0 Members and 1 Guest are viewing this topic.

Offline waldo786

  • Pinto Full Member
  • ***
  • Posts: 236
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Windows User Fifth year Anniversary
passenger door light
« on: June 02, 2013, 11:24:16 PM »
Hello all,


    It's been so long since I've used the old wagon I don't remember if there was a switch for the overhead light to come on when you open the passenger side door.  I do know there is not one in my Runabout and I found that a bit odd.  Is there supposed to be one there or not?  Thanks!

Offline Pinto5.0

  • Pinto Master
  • *****
  • Posts: 1974
  • FeedBack: +77/-0
  • Gender: Male
  • 80 hatch, 76 Wagon, 72 & 73 Sedans, 71 half hatch

  • Total Badges: 7
    Badges: (View All)
    Topic Starter Signature Poll Voter Mobile User Fifth year Anniversary Windows User 1000 Posts
Re: passenger door light
« Reply #1 on: June 02, 2013, 11:39:10 PM »
One of my Pintos only had a drivers side pin switch but I can't remember which one. I seem to remember the hole wasn't even drilled on the passenger side.
'73 Sedan (I'll get to it)
'76 Wagon driver
'80 hatch(Restoring to be my son's 1st car)~Callisto
'71 half hatch (bucket list Pinto)~Ghost
'72 sedan 5.0/T5~Lemon Squeeze

Offline blupinto

  • Pinto PooBAH
  • ******
  • Posts: 3872
  • FeedBack: +63/-0
  • Gender: Female
  • My Original Blu '72

  • Total Badges: 9
    Badges: (View All)
    Topic Starter Signature Mobile User Tenth year Anniversary Poll Voter Windows User 1000 Posts Fifth year Anniversary Photographer
Re: passenger door light
« Reply #2 on: June 03, 2013, 12:55:58 AM »
The pin switch should be on the front door jamb (where the hinges are). Mine don't always come on, regardless of which door is open. Sometimes they stick.  :)
One can never have too many Pintos!

Offline TIGGER

  • PCCA Charter Member
  • Pinto Master
  • *
  • Posts: 2424
  • FeedBack: +70/-0
  • Gender: Male

  • Total Badges: 10
    Badges: (View All)
    Topic Starter Signature Poll Voter Windows User Apple User Mobile User 1000 Posts Tenth year Anniversary Fifth year Anniversary Photographer
Re: passenger door light
« Reply #3 on: June 03, 2013, 03:20:54 PM »
Its an option as far as I know it.  I have had a couple cars without them, just a plug on the pass side door jam.  On my 78 hatch, I looked into installing one but the wiring was not behind the kick panel which I thought was odd.  I figure it would be wired?  Anyway since I was planning on selling the car I did not go thru the trouble of wiring it.
79 4cyl Wagon
73 Turbo HB
78 Cruising Wagon (sold 8/6/11)

Offline DBSS1234

  • Pinto Full Member
  • ***
  • Posts: 247
  • FeedBack: +29/-0
  • Gender: Male
  • Original owner 77 CW

  • Total Badges: 6
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter Windows User Fifth year Anniversary
Re: passenger door light
« Reply #4 on: June 04, 2013, 12:00:18 PM »
Unless you got the convience package you did not get a passenger side dome light switch. The hole was plugged with a little plastic plug. See the attached picture, the plastic plug is right at the silver/black paint break line on the front door pillar. The other plug is from an after market under coating job.