Current Classifieds

1978 Squire wagon 6 Cly
Date: 02/16/2020 05:42 pm
ENGINE COMPLETE 1971 PINTO
Date: 12/28/2017 03:55 pm
Wanted 1971-73 pinto 2.0 4 speed manual transmission
Date: 03/06/2019 06:40 pm
Front Body parts needed
Date: 02/09/2018 06:09 pm
Wanted 1973 Ford right fender
Date: 06/03/2017 08:50 pm
1974 Pinto Misc. moldings & parts

Date: 12/20/2016 10:47 pm
Wanted Postal Pinto
Date: 08/30/2021 03:20 pm
Sunroof shade
Date: 06/19/2019 01:33 pm
79 pinto small parts
Date: 04/24/2019 03:16 pm
EARLY PINTO CLUTCH PEDAL ASSEMBLY
Date: 02/14/2019 06:27 pm
Holley 4bbl carb. & Offenhauser intake.

Date: 08/09/2018 07:49 am
74 Wagon Interior
Date: 01/22/2017 06:38 pm

« previous next »
Pages: [1]   Go Down

Author Topic: new gas tank and fuel sending unit question  (Read 1387 times)

0 Members and 1 Guest are viewing this topic.

Offline waldo786

  • Pinto Full Member
  • ***
  • Posts: 236
  • FeedBack: +0/-0
  • Gender: Male

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Windows User Fifth year Anniversary
new gas tank and fuel sending unit question
« on: October 19, 2014, 09:24:53 PM »
So I installed a new fuel tank and a new fuel sending unit for my 76 hatchback.  I'm having trouble getting the electrical hookup back onto the sending unit.  Seems like no matter what I do it is just too short, like 1/8" or so.  I've tried to tighten the tank to get it as high as I can but it's in there seems like as tight as it'll go.  I'm wondering if anyone has any suggestions or has installed a new tank and had this issue?
Logged

Offline Pinto5.0

  • Pinto Master
  • *****
  • Posts: 1974
  • FeedBack: +77/-0
  • Gender: Male
  • 80 hatch, 76 Wagon, 72 & 73 Sedans, 71 half hatch

    • Total Badges: 7
    Badges: (View All)
    Topic Starter Signature Poll Voter Mobile User Fifth year Anniversary Windows User 1000 Posts
Re: new gas tank and fuel sending unit question
« Reply #1 on: October 19, 2014, 10:33:29 PM »
It sounds like the wire is pinched someplace. It should have some slack
Logged
'73 Sedan (I'll get to it)
'76 Wagon driver
'80 hatch(Restoring to be my son's 1st car)~Callisto
'71 half hatch (bucket list Pinto)~Ghost
'72 sedan 5.0/T5~Lemon Squeeze

Offline waldo786

  • Pinto Full Member
  • ***
  • Posts: 236
  • FeedBack: +0/-0
  • Gender: Male

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Windows User Fifth year Anniversary
Re: new gas tank and fuel sending unit question
« Reply #2 on: November 21, 2014, 04:50:26 PM »
Just an update, there was no wires pinched, but I did have to cut and extend the old wires and then use a snap connect female end to cover each male end of the fuel sending unit.  I haven't hooked up the battery or fired it up yet, but I'm hoping that works.
Logged
Pages: [1]   Go Up
« previous next »