Current Classifieds

74 Wagon Interior
Date: 01/22/2017 06:38 pm
1970-1973 Gas Tank/Blue Dash
Date: 02/07/2019 11:57 pm
WTB Cruising Wagon
Date: 12/07/2016 05:35 pm
76 station wagon parts needed.
Date: 03/14/2020 01:52 pm
79 pinto front,rear alum bumpers

Date: 07/17/2018 09:49 pm
hood for a 79-80
Date: 11/30/2018 10:55 pm
1977 Cruiser
Date: 06/29/2019 06:28 am
78 pinto wagon

Date: 03/03/2020 01:07 pm
78 pinto wagon

Date: 06/04/2020 12:42 pm
ford pinto door panels
Date: 03/20/2022 07:51 pm
Interior Parts
Date: 08/07/2017 03:59 pm
Needed- Good 71-73 Rear End or parts- close to AL
Date: 09/15/2019 12:38 pm

« previous next »
Pages: [1]   Go Down

Author Topic: New Carb  (Read 1022 times)

0 Members and 1 Guest are viewing this topic.

Offline danidanko

  • Pinto Driver
  • *
  • Posts: 1
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 1
    Badges: (View All)
    Topic Starter
New Carb
« on: June 08, 2018, 05:44:59 PM »
Hello, please see attached file, I got a 74 pinto and the carb is in pieces and I don't know where what goes when I put in a new carb, please help

In the picture have numbers and arrows, my questions are:

1) fuel inlet
2) decel port - what does it do where do I connect it to?
3) what is this inlet what does it do?
4 & 5)  what components do these coolant lines connect to?
6) where do I connect this (choke heater?, just 12v and returns via engine ground?)
Logged

Offline nnn0wqk

  • Pinto Member
  • **
  • Posts: 99
  • FeedBack: +24/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 5
    Badges: (View All)
    Topic Starter Poll Voter Windows User Tenth year Anniversary Fifth year Anniversary
Re: New Carb
« Reply #1 on: June 17, 2018, 10:23:13 AM »
Your number 1 goes down to the fuel pump. Should be a steel line between carb and pump with hoses on each end with filter screwing into carb.
Your number 2 I believe is the distributor advance line. I am not aware of a decel port used on 74 2.3l engine
I believe your number 3 is the line going over to the EGR system amplifier.
The choke water lines one connects to the steel line running along side the valve cover. The other to the fitting below carb in the intake manifold end.
The electric choke connects to a lead coming off the alternator. It is actually an AC voltage if I remember correctly. Comes off a stator tap.


Hopefully the pictures will help you out. These are off a 74 2.3l California emissions engine. Calibration number is C411R1
Logged
Pages: [1]   Go Up
« previous next »