Great you have the jack stands , better safe than (smashed ) sorry , use the breaker bar first to lossen the nuts , then the ratchet , then push the starter side bolt out , leave the drivers side where it is , use a pry bar (or the breaker bar to move the rack forward enough for that side to drop down , it install the drive clutch use remove the two bolts on the back of the starter , tap the nose of the starter and will come off easy, they will be a spring inside that fits between the nose and arm that pushes in the starter drive when you cranks the car, DO NOT PULL ON THE SHAFT, if you do and it come out you will have a fresh can of worms, at the end of the shaft you will see a cupped washer , remove , next a C- Clip , remove with care , they are known to vanish if they pop off , next is remove the top cover , no need the remove the band on the back, (note if the starter is a new style it will have a rear screw ) you will see a pin on the arm that that sticks in the starter drive, remove , pull on the drive and not the shaft , should come off easy , install new drive , now put everything back where you found them, good luck , hope this helps