Current Classifieds

Mustang II C4 Transmission
Date: 07/28/2017 06:26 am
Pinto or Bobcat wagon wanted
Date: 08/05/2018 10:49 pm
1979 Runabout Rear Panel
Date: 01/04/2020 02:03 pm
76 drivers fender
Date: 07/20/2018 08:24 pm
Odds and Ends 1976-77 Pinto Wagon

Date: 07/17/2019 05:23 pm
Early 2.0 engines
Date: 05/09/2018 12:45 pm
77 Cruising Wagon Front Seats
Date: 04/12/2017 12:37 pm
Looking for a few parts - TIA
Date: 02/19/2023 12:18 pm
1976 Ford Pinto

Date: 07/16/2019 02:51 am
1972 Rallye wagon rebuild
Date: 11/14/2020 07:31 pm
WTB Cruising Wagon
Date: 12/07/2016 05:35 pm
1978 Squire wagon 6 Cly
Date: 02/16/2020 05:42 pm

« previous next »
Pages: [1]   Go Down

Author Topic: new gas tank and fuel sending unit question  (Read 1391 times)

0 Members and 1 Guest are viewing this topic.

Offline waldo786

  • Pinto Full Member
  • ***
  • Posts: 236
  • FeedBack: +0/-0
  • Gender: Male

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Windows User Fifth year Anniversary
new gas tank and fuel sending unit question
« on: October 19, 2014, 09:24:53 PM »
So I installed a new fuel tank and a new fuel sending unit for my 76 hatchback.  I'm having trouble getting the electrical hookup back onto the sending unit.  Seems like no matter what I do it is just too short, like 1/8" or so.  I've tried to tighten the tank to get it as high as I can but it's in there seems like as tight as it'll go.  I'm wondering if anyone has any suggestions or has installed a new tank and had this issue?
Logged

Offline Pinto5.0

  • Pinto Master
  • *****
  • Posts: 1974
  • FeedBack: +77/-0
  • Gender: Male
  • 80 hatch, 76 Wagon, 72 & 73 Sedans, 71 half hatch

    • Total Badges: 7
    Badges: (View All)
    Topic Starter Signature Poll Voter Mobile User Fifth year Anniversary Windows User 1000 Posts
Re: new gas tank and fuel sending unit question
« Reply #1 on: October 19, 2014, 10:33:29 PM »
It sounds like the wire is pinched someplace. It should have some slack
Logged
'73 Sedan (I'll get to it)
'76 Wagon driver
'80 hatch(Restoring to be my son's 1st car)~Callisto
'71 half hatch (bucket list Pinto)~Ghost
'72 sedan 5.0/T5~Lemon Squeeze

Offline waldo786

  • Pinto Full Member
  • ***
  • Posts: 236
  • FeedBack: +0/-0
  • Gender: Male

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Windows User Fifth year Anniversary
Re: new gas tank and fuel sending unit question
« Reply #2 on: November 21, 2014, 04:50:26 PM »
Just an update, there was no wires pinched, but I did have to cut and extend the old wires and then use a snap connect female end to cover each male end of the fuel sending unit.  I haven't hooked up the battery or fired it up yet, but I'm hoping that works.
Logged
Pages: [1]   Go Up
« previous next »