Current Classifieds

1973 Bobcat Cruzin Wagon for Sale $4000 obo

Date: 04/13/2018 11:30 am
1980 Pinto for sale

Date: 11/24/2016 06:32 pm
72 pinto and 88 turbo coupe

Date: 06/09/2016 04:13 am
77 pinto
Date: 08/22/2017 06:31 pm
1980 Pinto for sale

Date: 11/24/2016 06:32 pm
1974 Ford Pinto

Date: 10/16/2017 10:45 am
$300 Pinto for sale

Date: 04/19/2017 10:24 am
Want seals for Pinto wagon "flip out" windows
Date: 08/08/2017 01:44 pm
Clutch Cable Needed
Date: 04/03/2017 10:54 pm
77 pinto cruz. wagon
Date: 06/15/2017 09:18 pm
$300 Pinto for sale

Date: 04/19/2017 10:24 am
1972 Runabout (GOING TO SCRAP BY 5/28)

Date: 05/21/2019 11:50 am

« previous next »
Pages: [1]   Go Down

Author Topic: Looking for cargo measurement  (Read 614 times)

0 Members and 1 Guest are viewing this topic.

Offline fordblue72

  • Pinto Member
  • **
  • Posts: 36
  • FeedBack: +3/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 7
    Badges: (View All)
    Tenth year Anniversary Fifth year Anniversary Topic Starter Poll Voter Apple User Mobile User Windows User
Looking for cargo measurement
« on: September 09, 2019, 08:00:40 PM »
Hello, I’m looking to purchase a 74 wagon, was wondering what the length and width of the cargo area with the back seats down. Thanks for any help.
Logged

Offline Wittsend

  • Pinto Master
  • *****
  • Posts: 2498
  • FeedBack: +241/-0

    • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter 1000 Posts Linux User Windows User Fifth year Anniversary
Re: Looking for cargo measurement
« Reply #1 on: September 10, 2019, 08:01:19 PM »
Front to Back:
There is 62-1/2" that is from the edge of the rear hatch to the front end of the folded down rear seat. If you are dealing with something flat (thin), have the seats full forward and little to no tilt you MIGHT get an additional 8"-12".  On the other hand if the seat is rearward and tilted back you start to lose space once the item is about 6"-8" vertical.

Side to Side:
The maximun flat width is 41-1/2" due to the wheel well intrusion. The maximum width at the rear hatch is 46."  I did not measure the full interior width because of the other limiting factors but I would estimate the area on the fore and aft sides of the wheel well is about 48."

Vertical:
The hatch hinges  are the limiting vertical issue. The maximum is 26-1/4" though the roof is about 2" higher.

Actual use:
  I was able to transport a washing machine ever so barely but had to remove the drain tube to get it to fit. I doubt all washers are the same size.  At first it seems a 48" wide sheet of plywwod will go in. And if you measure at the wheel wells it seems there is space for 48" as well. BUT..., the angles are different and I believe the plywood will not fit. Anyway, there isn't 96" for an 8 foot sheet anyway.


Logged

Offline fordblue72

  • Pinto Member
  • **
  • Posts: 36
  • FeedBack: +3/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 7
    Badges: (View All)
    Tenth year Anniversary Fifth year Anniversary Topic Starter Poll Voter Apple User Mobile User Windows User
Re: Looking for cargo measurement
« Reply #2 on: September 12, 2019, 12:38:41 AM »
Thank you very much, I really appreciate this,
I think this wagon is in my future.
Logged

Offline Wittsend

  • Pinto Master
  • *****
  • Posts: 2498
  • FeedBack: +241/-0

    • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter 1000 Posts Linux User Windows User Fifth year Anniversary
Re: Looking for cargo measurement
« Reply #3 on: September 12, 2019, 10:20:06 AM »
You're welcome. Glad I could help.

  One thing I forget to mention. As much as the seats being rearward/tilted eats up space..., the rear hatch tilts forward as it rises upward and space (8"-12") is taken up there was well. Still, for a "small" car there is a decent amount of space.
Logged
Pages: [1]   Go Up
« previous next »