Current Classifieds

71-73 Hood
Date: 12/07/2018 06:22 pm
1971 yellow Pinto hatchback with limited edition chrome strips on rear door, 1600 cc engine

Date: 02/26/2017 03:22 pm
SOME PARTS FOR SALE
Date: 01/11/2017 10:45 am
WTB 1974 or 1975 Pinto Grille and Turn Signals
Date: 04/08/2018 05:47 pm
Needed, 2.0 or 2.3 motors
Date: 09/30/2018 07:47 pm
1973 Pinto Runabout

Date: 08/17/2022 06:27 pm
79 pinto small parts
Date: 04/24/2019 03:16 pm
13" Style Steel Trim Rings

Date: 10/09/2020 10:35 pm
Needed- Good 71-73 Rear End or parts- close to AL
Date: 09/15/2019 12:38 pm
2.3 pinto carb
Date: 08/18/2018 02:07 pm
Needed, 2.0 or 2.3 motors
Date: 09/30/2018 07:47 pm
Automatic transmission
Date: 02/13/2021 02:52 pm

Author Topic: Jack stand placement  (Read 732 times)

0 Members and 1 Guest are viewing this topic.

Offline Jdm071755

  • Pinto Full Member
  • ***
  • Posts: 163
  • FeedBack: +24/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Mobile User
Jack stand placement
« on: September 30, 2017, 02:08:16 PM »
I'm going to start working on the front brakes and replacing the rag joint. Where is the safest place to put jack stands?

Thanks to everyone for all your help so far
Joe


Sent from my iPhone using Tapatalk
Joe

Offline dick1172762

  • Vintage Pinto Racer
  • PCCA Management Board
  • Pinto Sr. Master
  • ******
  • Posts: 2623
  • FeedBack: +362/-0
  • Gender: Male
  • I'm a llama!

  • Total Badges: 7
    Badges: (View All)
    Topic Starter Signature Poll Voter Windows User 1000 Posts Tenth year Anniversary Fifth year Anniversary
Re: Jack stand placement
« Reply #1 on: September 30, 2017, 02:16:11 PM »
Under the lower control arms out near the ball joints.
Its better to be a has-been, than a never was.