Current Classifieds

79 pinto front,rear alum bumpers

Date: 07/17/2018 09:49 pm
'78 Pinto Windshield Trim
Date: 05/09/2017 10:46 am
SOME PARTS FOR SALE
Date: 01/11/2017 10:45 am
2.0 Cyl Head1973
Date: 11/29/2018 12:51 pm
cam pulley
Date: 05/30/2018 04:56 pm
73 2.0 Timing Crank Gear & Woodruff key WANTED
Date: 09/01/2017 07:52 am
WTB Manual Transmission Clutch Pedal for '78
Date: 03/29/2019 07:20 am
74 Pinto Wagon Squire.Bright blue

Date: 06/30/2018 09:48 am
pinto floor mats??

Date: 01/11/2017 07:27 am
New cam

Date: 01/23/2017 05:11 pm
Need 76' coupe rear Glass and Front Grille
Date: 07/20/2017 01:23 am
Pinto Runabout wanted
Date: 06/05/2018 04:42 pm

« previous next »
Pages: [1]   Go Down

Author Topic: issues with the drivers side turn signals front and rear and break lights  (Read 1523 times)

0 Members and 1 Guest are viewing this topic.

Offline crakrr

  • Pinto Driver
  • *
  • Posts: 2
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Fifth year Anniversary Topic Starter
issues with the drivers side turn signals front and rear and break lights
« on: February 08, 2012, 11:02:27 AM »
ok so i just bought A 77 pinto and none of the marker lights in the drivers side work i pulled the bulbs and they all look good so im hoping that its just the bulb housings/ harnesses that are bad cause they are all rusted out how hard it it to find  these parts and do yall have any other ideas as to what may have caused this issue
Logged

Offline ToniJ1960

  • Pinto Sr. Member
  • ****
  • Posts: 544
  • FeedBack: +13/-0
  • Gender: Female
  • Another Pinto Driver

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Fifth year Anniversary Windows User
Re: issues with the drivers side turn signals front and rear and break lights
« Reply #1 on: February 08, 2012, 03:48:01 PM »
 I know the brake lights are wrired through the turn signal switch under the steering wheel, so dont rule it out if its not bad sockets bulbs or grounds.
Logged

Offline crakrr

  • Pinto Driver
  • *
  • Posts: 2
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Fifth year Anniversary Topic Starter
Re: issues with the drivers side turn signals front and rear and break lights
« Reply #2 on: February 13, 2012, 07:54:15 AM »
ok thanks toni i appreciate it ill take a look anyone else got any ideas
Logged

Offline bbobcat75

  • Pinto Master
  • *****
  • Posts: 1032
  • FeedBack: +71/-0
  • Gender: Male

    • Total Badges: 9
    Badges: (View All)
    Tenth year Anniversary Topic Starter Signature Poll Voter 1000 Posts Apple User Mobile User Windows User Fifth year Anniversary
Re: issues with the drivers side turn signals front and rear and break lights
« Reply #3 on: February 13, 2012, 06:26:49 PM »
check the grounds in the sockets and on the body, my 78 would work then not work it was the sockets! had to find old ones that where not all worn out!! good luck hope this helps,
 
eric
Logged
1975 mercury bobcat 2.8 auto
1978 mercury bobcat wagon 2.3l - soon to have a 88 tc drive line - SOLD - 🙁
1975 ford pinto - drag car - 2.3l w/t5 trans - project car

Offline Farmboy

  • Pinto Sr. Member
  • ****
  • Posts: 431
  • FeedBack: +0/-0
  • Gender: Male

    • Total Badges: 6
    Badges: (View All)
    Topic Starter Signature Poll Voter Windows User Tenth year Anniversary Fifth year Anniversary
Re: issues with the drivers side turn signals front and rear and break lights
« Reply #4 on: February 13, 2012, 08:05:38 PM »
I got all my new sockets at NAPA. One of the best this I could have done
Logged
  I do what the voices in my Pinto tell me to do




74 Pinto Wagon
71 Runabout (parts car)
Pages: [1]   Go Up
« previous next »