PINTO CAR CLUB of AMERICA

Welcome to FordPinto.com, The home of the PCCA => General Help- Ask the Experts... => Topic started by: crakrr on February 08, 2012, 11:02:27 AM

Title: issues with the drivers side turn signals front and rear and break lights
Post by: crakrr on February 08, 2012, 11:02:27 AM

ok so i just bought A 77 pinto and none of the marker lights in the drivers side work i pulled the bulbs and they all look good so im hoping that its just the bulb housings/ harnesses that are bad cause they are all rusted out how hard it it to find  these parts and do yall have any other ideas as to what may have caused this issue

Title: Re: issues with the drivers side turn signals front and rear and break lights
Post by: ToniJ1960 on February 08, 2012, 03:48:01 PM

 I know the brake lights are wrired through the turn signal switch under the steering wheel, so dont rule it out if its not bad sockets bulbs or grounds.

Title: Re: issues with the drivers side turn signals front and rear and break lights
Post by: crakrr on February 13, 2012, 07:54:15 AM

ok thanks toni i appreciate it ill take a look anyone else got any ideas

Title: Re: issues with the drivers side turn signals front and rear and break lights
Post by: bbobcat75 on February 13, 2012, 06:26:49 PM

check the grounds in the sockets and on the body, my 78 would work then not work it was the sockets! had to find old ones that where not all worn out!! good luck hope this helps,
 
eric

Title: Re: issues with the drivers side turn signals front and rear and break lights
Post by: Farmboy on February 13, 2012, 08:05:38 PM

I got all my new sockets at NAPA. One of the best this I could have done