Current Classifieds

1.6 New Ford cylinder head with side draft carbs

Date: 06/12/2018 08:18 pm
Pinto Vinyl Top

Date: 10/09/2020 10:29 pm
SOME PARTS FOR SALE
Date: 01/11/2017 10:45 am
'72 Runabout Drivers Side Door Hinge Set
Date: 12/15/2018 02:21 am
72 Pinto parts
Date: 12/04/2018 09:56 pm
1980 Ford Pinto Squire Wagon * All original 1 Owner *

Date: 09/15/2019 12:28 pm
1973 Interior parts wanted
Date: 01/02/2017 11:02 pm
72 Runabout for Sale- Washington

Date: 02/28/2024 02:07 pm
1600 CC WATER PUMP
Date: 06/02/2018 09:13 am
Parting out 77 Bobcat Hatch
Date: 11/06/2017 04:16 pm
Wiring diagram Ignition switch 72 2.0 4 speed pinto wagon
Date: 12/31/2017 11:14 pm
72 Pinto Wagon for sale

Date: 12/31/2017 08:40 pm

Author Topic: is this correct part # ?  (Read 1230 times)

0 Members and 1 Guest are viewing this topic.

Offline dmsteen

  • Pinto Full Member
  • ***
  • Posts: 130
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Fifth year Anniversary
is this correct part # ?
« on: April 02, 2013, 05:14:56 PM »
I have part # D5FZ-7329164A and 5A listed for L @ R rear wheel moldings for 77-80 wagon.i have been told that only 79 @ 80 are the same. does anybody know for sure ? it might make it a little easier to find a pair cause it seems impossible to find a set in any condition
 
thanx dave

Offline 289Wagon

  • Pinto Full Member
  • ***
  • Posts: 234
  • FeedBack: +29/-3
  • Gender: Male

  • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Fifth year Anniversary
Re: is this correct part # ?
« Reply #1 on: April 03, 2013, 06:22:16 AM »
I sent this info to you in a PM awhile back, but I never got a reply.
 The rears are the same from '75 (with the 1-1/2 wide molding) thru '80.
 It was the front that changed in '79.
Still living the dream...In a points & condenser world.

Offline dmsteen

  • Pinto Full Member
  • ***
  • Posts: 130
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Fifth year Anniversary
Re: is this correct part # ?
« Reply #2 on: April 03, 2013, 03:51:16 PM »
I never got the pm  but thanx for the info !! this will help a lot !!