Current Classifieds

turbo 4 cyl and aod trans
Date: 12/14/2019 04:55 pm
1978 Squire wagon 6 Cly
Date: 03/08/2021 10:44 am
Chilton's Repair & Tune-up Guide 1971-1979 Pinto and Bobcat

Date: 03/06/2017 01:24 am
Rally spoiler wanted
Date: 05/04/2017 01:32 pm
WANTED: Skinny Rear Bumper w/o guards for '71 or '72 Pinto Coupe
Date: 04/24/2018 11:45 am
72 pinto and 88 turbo coupe

Date: 06/09/2016 04:13 am
Wanted - Offenhauser intake for 2.8l (6097DP)
Date: 01/28/2019 05:15 pm
Brake rotors
Date: 03/24/2017 09:02 pm
hubcaps

Date: 10/31/2018 12:04 pm
1971 Pinto Parting out

Date: 07/06/2018 01:11 pm
1974 Pinto Passenger side door glass and door parts

Date: 02/18/2017 05:55 pm
1978 ford pinto carb
Date: 02/04/2018 06:09 pm

Author Topic: is this correct part # ?  (Read 1228 times)

0 Members and 1 Guest are viewing this topic.

Offline dmsteen

  • Pinto Full Member
  • ***
  • Posts: 130
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Fifth year Anniversary
is this correct part # ?
« on: April 02, 2013, 05:14:56 PM »
I have part # D5FZ-7329164A and 5A listed for L @ R rear wheel moldings for 77-80 wagon.i have been told that only 79 @ 80 are the same. does anybody know for sure ? it might make it a little easier to find a pair cause it seems impossible to find a set in any condition
 
thanx dave

Offline 289Wagon

  • Pinto Full Member
  • ***
  • Posts: 234
  • FeedBack: +29/-3
  • Gender: Male

  • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Fifth year Anniversary
Re: is this correct part # ?
« Reply #1 on: April 03, 2013, 06:22:16 AM »
I sent this info to you in a PM awhile back, but I never got a reply.
 The rears are the same from '75 (with the 1-1/2 wide molding) thru '80.
 It was the front that changed in '79.
Still living the dream...In a points & condenser world.

Offline dmsteen

  • Pinto Full Member
  • ***
  • Posts: 130
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Fifth year Anniversary
Re: is this correct part # ?
« Reply #2 on: April 03, 2013, 03:51:16 PM »
I never got the pm  but thanx for the info !! this will help a lot !!