PINTO CAR CLUB of AMERICA
Welcome to FordPinto.com, The home of the PCCA => General Help- Ask the Experts... => Topic started by: dianne on September 21, 2013, 02:35:33 PM
-
Does anyone know where I might be able to order gaskets for a Pinto? Harder than heck to find them...
I need the o-ring and gasket for a distributor and also the fuel pump gasket.
Thanks,
Dianne
-
Fel-Pro has all the gaskets you need, may have to order them though as a lot of parts places don't stock 2.0/2.3 stuff.
-
I have some extra distributor o-rings in the parts I have for you, as well as the original fomoco fuel pump which was good when pulled but I felt better with a new one. I kept it around as a good spare. No gasket for it though. They can easily be cut out of a sheet of gasket paper though!
-
Thinking the very common smallblock chevy fuel pump gasket works fine there, the two bolt one not the four.
-
Thinking the very common smallblock chevy fuel pump gasket works fine there, the two bolt one not the four.
Early 2.0 uses an odd pump, with a vertical bolt pattern. Not sure for the 2.3 as I don't have one, but the part listed on O'Reilly's website does look like a standard SBC pump, so it very well might work in that application. If you have a 2.3, parts availability shouldn't be a big issue, since they were used in tons of vehicles.
Site says the 2.8 uses the same FP gasket as the 71-72 2.0's. YMMV. What motor are you running?
I've had good luck with sourcing parts from RockAuto.com, if it's not something of immediate need (shipping time).
-
I just replaced the fuel pump on my 2.3 and it does take a SBC gasket.
-
You're making me dig in the cobwebs, thinking about it, I do remember that vertical pattern pump mount......... ...man it's dark in that hard drive.