Current Classifieds

1972 Rallye wagon rebuild
Date: 11/14/2020 07:31 pm
1974 Wiring diagram free
Date: 10/27/2019 06:56 pm
Wanted Postal Pinto
Date: 10/26/2020 03:24 pm
1978 bobcat 4speed shifter
Date: 11/02/2023 09:51 pm
13" Style Steel Trim Rings

Date: 10/09/2020 10:35 pm
'76 Wagon Driver Side Rear Interior Panel
Date: 11/11/2019 04:49 pm
Pinto Wagon
Date: 05/25/2018 01:50 pm
1971 yellow Pinto hatchback with limited edition chrome strips on rear door, 1600 cc engine

Date: 02/26/2017 03:22 pm
Pinto for sale

Date: 04/19/2017 10:15 am
Looking for Radiator and gas tank
Date: 10/24/2018 07:41 am
NEED 77/78 MUSTANG II Left Motor Mount
Date: 04/15/2017 05:14 pm
76 pinto sedan sbc/bbc project for sale $1700 obo

Date: 03/27/2017 10:07 pm

« previous next »
Pages: [1]   Go Down

Author Topic: Dome light  (Read 743 times)

0 Members and 1 Guest are viewing this topic.

Offline sedandelivery

  • Pinto Sr. Member
  • ****
  • Posts: 460
  • FeedBack: +30/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Fifth year Anniversary Windows User
Dome light
« on: March 01, 2020, 01:36:32 PM »
On my '80 Bobcat, when you open the door, the seat belt solenoids kick in, the buzzer goes off if the key is in, but the dome light does not work, no power is applied to the light. Ideas? One fuse is supposed to work all three.
Logged

Offline 71pintoracer

  • Pinto Master
  • *****
  • Posts: 1336
  • FeedBack: +37/-0
  • Gender: Male
  • '71 Pinto 5.0 T-5 = lotsa fun!

    • Total Badges: 8
    Badges: (View All)
    Mobile User Tenth year Anniversary Topic Starter Signature Poll Voter 1000 Posts Fifth year Anniversary Photographer
Re: Dome light
« Reply #1 on: March 01, 2020, 05:49:35 PM »
I have an '80 model wiring diagram at work, I'll see how the circuit works and get back to you. You say there is no power so I'm guessing here, you used a voltmeter or test light at the bulb terminal?
Logged
If you don't have time to do it right, when will you have time to do it over?

Offline sedandelivery

  • Pinto Sr. Member
  • ****
  • Posts: 460
  • FeedBack: +30/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Fifth year Anniversary Windows User
Re: Dome light
« Reply #2 on: March 01, 2020, 08:45:24 PM »
Yes, in the roof area you have a ground but no voltage. Weird everything is working but that! Before I tear into it, I thought someone might have an idea.
Logged

Offline oldkayaker

  • Pinto Master
  • *****
  • Posts: 758
  • FeedBack: +114/-0
  • Gender: Male

    • Total Badges: 5
    Badges: (View All)
    Topic Starter Signature Windows User Tenth year Anniversary Fifth year Anniversary
Re: Dome light
« Reply #3 on: March 02, 2020, 04:56:12 AM »
According to a 1980 Pinto EVTM, the 1980 door switches each contain two switches (1 power in & 2 power out).  One power out goes to the key buzzer & seat belt.  The other power out goes to the dome light.  Suspect the door switch is not operating properly.  Try opening the other door to see if that switch works.  May need to repair or replace door switch. 
Logged
Jerry J - Jupiter, Florida

Offline sedandelivery

  • Pinto Sr. Member
  • ****
  • Posts: 460
  • FeedBack: +30/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Fifth year Anniversary Windows User
Re: Dome light
« Reply #4 on: March 02, 2020, 07:36:52 AM »
Both doors same problem. Good place to start, maybe one switch feeds off the other one, hence if the passenger switch is bad. the buzzer and the seatbelt thing would work, but not the light! Thank you, I will investigate!
Logged

Offline HOSS429

  • Pinto Full Member
  • ***
  • Posts: 222
  • FeedBack: +22/-0
  • old ford guy

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Fifth year Anniversary Topic Starter Poll Voter Windows User
Re: Dome light
« Reply #5 on: March 02, 2020, 08:00:50 AM »
take your finger and push the door switch in and let it pop back out quickly several times ..  sometimes due to slow action of the door working over the years the contacts will corrode a little and the slow motion of the door opening will not complete the connection .. snap each button a few times ..
Logged

Offline HOSS429

  • Pinto Full Member
  • ***
  • Posts: 222
  • FeedBack: +22/-0
  • old ford guy

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Fifth year Anniversary Topic Starter Poll Voter Windows User
Re: Dome light
« Reply #6 on: March 02, 2020, 08:10:46 AM »
i`m sure you know you can access the wires by removing the kick panels to check if there is voltage present going to the switches .
Logged

Offline 71pintoracer

  • Pinto Master
  • *****
  • Posts: 1336
  • FeedBack: +37/-0
  • Gender: Male
  • '71 Pinto 5.0 T-5 = lotsa fun!

    • Total Badges: 8
    Badges: (View All)
    Mobile User Tenth year Anniversary Topic Starter Signature Poll Voter 1000 Posts Fifth year Anniversary Photographer
Re: Dome light
« Reply #7 on: March 02, 2020, 11:20:38 AM »
Did you try turning the headlamp knob to the left to see if the dome came on? Uses the same circuit, light blue/ black is the color code.
Logged
If you don't have time to do it right, when will you have time to do it over?
Pages: [1]   Go Up
« previous next »