Current Classifieds

1976 Pinto

Date: 10/24/2017 02:00 pm
2.8 Engine mount brackets
Date: 12/28/2016 11:42 am
WANTED: Dash, fender, hood, gauge bezel '73 Wagon
Date: 01/18/2017 05:35 pm
79-80 fenders, hood, rallye wheels, light buckets, etc, C3 trans
Date: 01/04/2017 04:07 am
1978 pinto brake booster needed.
Date: 04/07/2021 06:12 pm
78-80 Windshield
Date: 10/29/2021 03:11 pm
Rally spoiler wanted
Date: 05/04/2017 01:32 pm
1973 Pangra gauge and tach panel

Date: 11/02/2019 10:25 am
1980 Pinto Parts

Date: 08/05/2020 04:20 pm
1972 Runabout 351 Cleveland V8

Date: 11/05/2016 09:03 pm
Misc pinto parts 71-73 2.0
Date: 05/05/2020 11:56 pm
1971 Pinto Runabout turn key driver

Date: 12/04/2018 07:40 pm

« previous next »
Pages: [1]   Go Down

Author Topic: Cast valve cover question... 2.3  (Read 1036 times)

0 Members and 1 Guest are viewing this topic.

Offline 76hotrodpinto

  • Pinto Sr. Member
  • ****
  • Posts: 692
  • FeedBack: +13/-0
  • Gender: Male

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Windows User
Cast valve cover question... 2.3
« on: January 20, 2015, 01:11:54 PM »
Looking at the "fuel injection turbo" cast valve cover, and on the gasket side of the mounting flange, it has stand off sleeves on the bolt holes. It has them in all but one, front/exhaust side. Is that one missing? Or just not supposed to be one in that hole?
Logged
1976 half hatch 2.3 turbo w/t5.

Offline 76hotrodpinto

  • Pinto Sr. Member
  • ****
  • Posts: 692
  • FeedBack: +13/-0
  • Gender: Male

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Windows User
Re: Cast valve cover question... 2.3
« Reply #1 on: January 21, 2015, 09:42:12 PM »
Nevermind. Looks to have been an attempt to not squish the gasket out. Popped them out and milled it smooth again. Tapped the hole and cleaned it up. Will put in my non turbo, non fuel injected motor when it get's a little warmer.
Logged
1976 half hatch 2.3 turbo w/t5.
Pages: [1]   Go Up
« previous next »