14 Guests, 0 Users

« previous next »
Pages: [1]   Go Down

Author Topic: Cast valve cover question... 2.3  (Read 871 times)

0 Members and 1 Guest are viewing this topic.

Offline 76hotrodpinto

  • Pinto Sr. Member
  • ****
  • Posts: 692
  • FeedBack: +13/-0
  • Gender: Male

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Windows User
Cast valve cover question... 2.3
« on: January 20, 2015, 01:11:54 PM »
Looking at the "fuel injection turbo" cast valve cover, and on the gasket side of the mounting flange, it has stand off sleeves on the bolt holes. It has them in all but one, front/exhaust side. Is that one missing? Or just not supposed to be one in that hole?
Logged
1976 half hatch 2.3 turbo w/t5.

Offline 76hotrodpinto

  • Pinto Sr. Member
  • ****
  • Posts: 692
  • FeedBack: +13/-0
  • Gender: Male

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Windows User
Re: Cast valve cover question... 2.3
« Reply #1 on: January 21, 2015, 09:42:12 PM »
Nevermind. Looks to have been an attempt to not squish the gasket out. Popped them out and milled it smooth again. Tapped the hole and cleaned it up. Will put in my non turbo, non fuel injected motor when it get's a little warmer.
Logged
1976 half hatch 2.3 turbo w/t5.
Pages: [1]   Go Up
« previous next »