Got it running a few days ago by just changing the battery with a new one
Today when I tried to run it, It would not idle for more than a few secs then die and if you gave it any throttle response it would die
Check the vacuum advance and its alright, so I took the advance line off the ported side of the carb and hooked it to straight manifold vacuum and put
The power valve vacuum line to the ported carb port. Now it runs? What’s with this are the plates in the dizzy getting sticky
Also the venturis are dripping gas, more so after acceleration is this normal or is it a float level or throttle plate positioning issue
Finally the battery is charging its 12.45v @ standstill and 14.75 v @ 1000-1200 rpms and its stable, I want to see if it would stay running without the battery but I do not want to remove it while running in case of damage