Current Classifieds

1972 pinto grill
Date: 02/27/2018 12:13 am
need a Ford battery for a 77 Pinto
Date: 02/21/2017 06:29 am
79-80 fenders, hood, rallye wheels, light buckets, etc, C3 trans
Date: 01/04/2017 04:07 am
1976 Ford Pinto Pony
Date: 09/06/2018 05:40 pm
Needed- Good 71-73 Rear End or parts- close to AL
Date: 09/15/2019 12:38 pm
Pinto Runabout wanted
Date: 06/05/2018 04:42 pm
95 2.3l short block
Date: 03/18/2017 04:54 pm
1971 Pinto 5.0L

Date: 12/02/2017 12:23 am
Wanted early pinto
Date: 10/03/2019 02:42 pm
1978 FORD PINTO PONY FOR SALE 17.000 MILES !!!!!!!!!!!!

Date: 06/25/2021 12:59 am
73 actuator for heater blend door
Date: 09/19/2019 04:43 pm
Ford 2.3L new gaskets for sale
Date: 12/10/2016 04:11 pm

Author Topic: Been Preparing for a v8 swap into My 76! (Motor Mounts)  (Read 1357 times)

0 Members and 1 Guest are viewing this topic.

Offline Glitch666

  • Pinto Full Member
  • ***
  • Posts: 118
  • FeedBack: +1/-0
  • Gender: Male

  • Total Badges: 6
    Badges: (View All)
    Topic Starter Poll Voter Linux User Mobile User Windows User Fifth year Anniversary
Been Preparing for a v8 swap into My 76! (Motor Mounts)
« on: August 14, 2012, 12:30:16 AM »
Just wanted to verify that you can in deed use the stock 2.3 frame horns (drivers side need to be moved back an inch). Then use the mustang 2 motor mounts if I can ever find or afford them. Then it comes down to the engine side of the the mount, I was wondering if there was a substitute for this part as I found these locally.


  • Guest
Re: Been Preparing for a v8 swap into My 76! (Motor Mounts)
« Reply #1 on: August 14, 2012, 10:11:35 PM »
If they aren't Mustang II engine mounts the engine won't sit where it needs to. Using those mounts from Oreily's would push the engine up quite a bit if you could even the engine mount bolt thru them and the frame bracket.