Current Classifieds

INTERIOR DELUX ARM RESTS - 2 PAIR

Date: 03/23/2018 09:23 pm
72 Pinto parts
Date: 11/14/2019 10:46 pm
parting out 1975 & 80 pintos
Date: 08/24/2018 02:50 pm
1975 Ford Pinto

Date: 01/13/2020 11:02 am
Custom Pinto Project

Date: 06/12/2016 07:37 pm
2.0 performance parts, 2 intakes, header, ported head, more
Date: 10/25/2019 04:05 pm
78 Cruising Wagon at Mecum Chattanooga

Date: 09/02/2021 08:21 am
71,72 Pinto Door Panels

Date: 06/17/2018 08:27 pm
95 2.3l short block
Date: 03/18/2017 04:54 pm
Pinto Watch

Date: 06/22/2019 07:12 pm
95 2.3l short block
Date: 03/18/2017 04:54 pm
2.0 Cyl Head1973
Date: 11/29/2018 12:51 pm

Author Topic: visors  (Read 907 times)

0 Members and 1 Guest are viewing this topic.

Offline JoeBob

  • Pinto Sr. Member
  • ****
  • Posts: 514
  • FeedBack: +51/-0
  • Gender: Male

  • Total Badges: 7
    Badges: (View All)
    Photographer Topic Starter Signature Tenth year Anniversary Poll Voter Windows User Fifth year Anniversary
visors
« on: August 03, 2015, 05:55:46 PM »
The stick in my visors is broken. Got some from the junk yard , wrong color. I do not know how to remove the stick. I don't want to pull hard for fear that replacements are fragile. How are the sticks held in place? How do I remove them?
Thank you
77 yellow Bobcat hatchback
Deuteronomy 7:9

Offline TIGGER

  • PCCA Charter Member
  • Pinto Master
  • *
  • Posts: 2408
  • FeedBack: +70/-0
  • Gender: Male

  • Total Badges: 10
    Badges: (View All)
    Topic Starter Signature Poll Voter Windows User Apple User Mobile User 1000 Posts Tenth year Anniversary Fifth year Anniversary Photographer
Re: visors
« Reply #1 on: August 03, 2015, 08:11:48 PM »
Its friction that holds them in.  You will need to get out the broken piece from your existing visor.  I drill a hole and then screw in a long sheetrock screw.  Then take pliars and pull on the screw head.  It may come out on one shot or you may have to drill and pull a couple times.  It just depends on how fragile the plastic is.

To remove a good pin, I take a rag and some pliars and pull.  You have to make sure the rag is thick or you will mar up the plastic.  Else if you do not care about the doner visor, I would just cut the metal shaft out of the visor and pry the tube apart to release the pin.

Then you need to go to one of the early Mustang parts suppliers and buy some new rubber ends.

Good luck
79 4cyl Wagon
73 Turbo HB
78 Cruising Wagon (sold 8/6/11)