Current Classifieds

74 Wagon Interior
Date: 01/22/2017 06:38 pm
I have a 1977 Cobra body lots of parts here
Date: 04/12/2017 06:57 pm
Clutch Fork
Date: 03/31/2018 09:12 pm
MISC PINTO PARTS

Date: 08/27/2017 10:23 am
74 Wagon Interior
Date: 01/22/2017 06:38 pm
1973 Pinto Wagon

Date: 05/06/2022 05:13 pm
WTB: Ford Type 9 5spd Transmission
Date: 03/18/2020 01:30 am
1974 Pinto Passenger side door glass and door parts

Date: 02/28/2018 09:18 am
72 pinto drag car

Date: 06/22/2017 07:19 am
1972 Runabout 351 Cleveland V8

Date: 11/05/2016 09:03 pm
4 speed pinto transmission

Date: 01/24/2021 07:54 pm
Clutch Pedals for 75to 80 Pinto
Date: 09/21/2018 11:35 am

« previous next »
Pages: [1]   Go Down

Author Topic: Shorten the FOG 4sp output?  (Read 1015 times)

0 Members and 1 Guest are viewing this topic.

Offline mr.mindless

  • Pinto Driver
  • *
  • Posts: 1
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Apple User
Shorten the FOG 4sp output?
« on: December 24, 2015, 01:47:58 PM »
I recently picked up a '74 2300 motor and trans for a microtruck re-power project. The motor is taller than I'd like, but I think I can deal with that - what has me completely stopped on using this donor is the enormously long output shaft on that FOG 4 speed. I've found nothing at all on anyone else wanting to shorten that output, nor have I been able to find much on transmission overall lengths.

I need to loose about a foot at bare minimum.

Anyone have an exploded diagram of the FOG?
Thoughts on a shorter transmission?
Experience hacking a foot of the output housing, shift rods, and mainshaft, and re-splining, drilling, and tapping it for a bolt on yoke? Hah.

Thanks,
Logged

Offline pinto_one

  • Pinto Master
  • *****
  • Posts: 1008
  • FeedBack: +70/-0
  • Gender: Male
  • Pinto-One

    • Total Badges: 10
    Badges: (View All)
    1000 Posts Photographer Tenth year Anniversary Topic Starter Signature Poll Voter Mobile User Apple User Windows User Fifth year Anniversary
Re: Shorten the FOG 4sp output?
« Reply #1 on: December 24, 2015, 04:10:28 PM »
If you have to knock a foot off of the trans you might as well use a different transmission, the trans you have now has the shifter built into the tail shaft , what you can do is buy the adaptor to use a old jeep transmission, the 2.3 was a good engine swap into the jeep back then, might want to check out a place called transdapet , they might still be around, hope this helps

Logged
76 Pinto sedan V6 , 79 pinto cruiser wagon V6 soon to be diesel or 4.0
Pages: [1]   Go Up
« previous next »