Current Classifieds

t-5 2.3 trans and new flywheel cluch and pressure plate though out bearing for sale
Date: 09/12/2018 04:07 pm
Wiring diagram Ignition switch 72 2.0 4 speed pinto wagon
Date: 12/31/2017 11:14 pm
convert to stick
Date: 05/19/2018 09:26 pm
'79 4 speed manual shifter needed
Date: 07/30/2018 04:32 pm
Mini Mark IV one of 2 delux lg. sunroof models
Date: 06/18/2018 03:47 pm
6.6.75 carrier
Date: 02/14/2018 06:47 am
2.3/C-4 torque converter needed
Date: 02/08/2018 02:26 pm
78 windshield trim
Date: 02/01/2020 08:46 am
Wanted Type 9 5spd Transmission
Date: 07/04/2017 03:26 pm
Mint Original Black Rear Seat $275.00

Date: 07/30/2020 11:45 am
Mustang II C4 Transmission
Date: 07/28/2017 06:26 am
rear hatch back louvers

Date: 04/18/2017 12:44 pm

Author Topic: Keeping A/C on Turbo Coupe Engine  (Read 1229 times)

0 Members and 1 Guest are viewing this topic.

Offline righthandman

  • Pinto Member
  • **
  • Posts: 49
  • FeedBack: +3/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Topic Starter Windows User
Keeping A/C on Turbo Coupe Engine
« on: July 01, 2013, 02:48:49 AM »
OK Guys, Here it is I have a 77 with a 2.3 & C-3 w/air and I bought an 88 Turbo Coupe to swap the engine and a C-4 transmission into the Pinto. I was thinking I would drive this car in the stampede again this year and need to have the air serviced before that, but I can't get the engine job done before that. So if I get this air worked on now am I going to be able to set the compressor off to the side without taking the lines off and losing the charge when I change the engine? Or would I be much better off to just wait until I change the engine and use the smaller compressor that is in use on the Turbo Coupe now? So what compressor are you guys using & is space a problem with the turbo crap? And am I going to be able to keep my battery up front?   Thanks in advance

Offline Pinto5.0

  • Pinto Master
  • *****
  • Posts: 1974
  • FeedBack: +77/-0
  • Gender: Male
  • 80 hatch, 76 Wagon, 72 & 73 Sedans, 71 half hatch

  • Total Badges: 7
    Badges: (View All)
    Topic Starter Signature Poll Voter Mobile User Fifth year Anniversary Windows User 1000 Posts
Re: Keeping A/C on Turbo Coupe Engine
« Reply #1 on: July 01, 2013, 05:53:29 AM »
The turbo sits where the battery normally goes so it has to be moved. I've seen some put in the front of the engine bay using the T-bird battery tray.
'73 Sedan (I'll get to it)
'76 Wagon driver
'80 hatch(Restoring to be my son's 1st car)~Callisto
'71 half hatch (bucket list Pinto)~Ghost
'72 sedan 5.0/T5~Lemon Squeeze

Offline D.R.Ball

  • Pinto Sr. Member
  • ****
  • Posts: 558
  • FeedBack: +36/-2
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Topic Starter Tenth year Anniversary Poll Voter Windows User Fifth year Anniversary
Re: Keeping A/C on Turbo Coupe Engine
« Reply #2 on: July 01, 2013, 04:54:56 PM »
Get the service done first if your not doing the swap yet. The 1988 T-Bird has an computer controlled A/C system that is run by the EEC. You can just add the switches and those parts that make the system work when your doing the swap and you might be able to move things to the side but right know just get the original system serviced. You have to do allot of changes to the harness of the Pinto to make things work. If it's working now leave it alone, the place that will do the service should be able to recover any R-12 that is in the system before you do the swap any way, so they should be able to give you a credit for it when you finish the swap and have the A/C hooked up. That is why you can't buy R-12  for your use  but the service guys can and recover any left in the system while it's being purged etc. You can move the battery tray to the drivers side by using some L channel and flat bar stock. This is what I'll be doing this week.