Current Classifieds

Clutch Cable Needed
Date: 04/03/2017 11:03 pm
74 hood
Date: 07/03/2017 03:46 pm
Weiand Single plane manifold - for 72 Pinto 4 barrel Carb
Date: 04/25/2017 12:17 pm
Plug Or Cover For Hatch Hinge Bolt For 1979
Date: 05/28/2017 03:20 pm
McLeod Clutch

Date: 04/12/2017 12:08 pm
PINTO TRUNK LATCH & CATCH

Date: 03/23/2018 09:39 pm
1978 PINTO PONY FOR SALE 17,000 ORIGINAL MILES !!!!!!!
Date: 10/10/2019 10:02 pm
Ford 2.3 Bellhousing C4/C5 & Torque Converter

Date: 07/08/2022 11:51 pm
1980 cruising wagon ralley

Date: 07/12/2019 01:41 pm
Holley 4bbl carb. & Offenhauser intake.

Date: 08/09/2018 07:49 am
78 hatchback

Date: 03/12/2023 06:50 pm
Built and Injected early 2000cc Engine

Date: 04/10/2017 07:30 pm

Author Topic: 2.3L dies  (Read 1844 times)

0 Members and 1 Guest are viewing this topic.

Offline Bigfoot79

  • Pinto Driver
  • *
  • Posts: 4
  • FeedBack: +0/-0
  • Gender: Male
  • Pinto power

  • Total Badges: 1
    Badges: (View All)
    Topic Starter
2.3L dies
« on: July 09, 2012, 10:16:12 PM »
Im just starting to learn about the 2.3L. My question is, it fires up well and runns pretty good in the driveway but as soon as it gets up to temp and you go around the block it starts to run a little rough and will die when you come to a stop. It will start again with a little effort but wants to die again if you don't keep the RPM'S up. I'm not sure what kind of carb it is but it's a two barrel and on the side of the electric choke it does say motorcraft. I changed the fuel filter and it is never empty so it doesn't seem to be a delivery problem, so that leeds me to believe its carb related?  Any guidence would be appreciated thanks guys

griffon

  • Guest
Re: 2.3L dies
« Reply #1 on: July 09, 2012, 10:26:15 PM »
Not very familiar with the Pinto 2.3 either but it sounds like your choke may be your problem.  Again, not very versed in these motors but have had similar problems to yours and was choke related.

Offline Bigfoot79

  • Pinto Driver
  • *
  • Posts: 4
  • FeedBack: +0/-0
  • Gender: Male
  • Pinto power

  • Total Badges: 1
    Badges: (View All)
    Topic Starter
Re: 2.3L dies
« Reply #2 on: July 10, 2012, 11:42:20 PM »
We are on the same page. The choke was the first thing I checked and it opening up fine.

75bobcatv6

  • Guest
Re: 2.3L dies
« Reply #3 on: July 11, 2012, 03:56:11 AM »
have you tried increasing the Fast idle? or the Air fuel? could be a gunked up carb too. mine was that way till i rebuilt it.


Offline newshirt

  • Pinto Driver
  • *
  • Posts: 4
  • FeedBack: +0/-0
  • Gender: Male
  • 1974 Runabout

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Signature
Re: 2.3L dies
« Reply #4 on: July 27, 2012, 09:27:03 AM »
99% of carb problems are ignition related.  (that's a joke, but usually true.)  The problem may be weak spark caused by a carbon burn path to ground, or short circuit.  Have you gone over your dist, rotor, coil, and cables?  Maybe the spark becomes so weak after warming up that you have to keep the rpm's up to stay running.  Does it backfire when you rev it up?  That's a sign of weak spark because unburned fuel collects in the exhaust and then ignites. Have you tried a C-Spark device to check the strength of the coil voltage?
Ray White
'74 runabout, gave to a friend in '82
'78 runabout, gave to different friend in '84
'29 model a, no plans to give it away