PINTO CAR CLUB of AMERICA
Welcome to FordPinto.com, The home of the PCCA => General Help- Ask the Experts... => Topic started by: r4pinto on September 15, 2016, 08:07:33 AM
-
Hey guys
in 2012 I started to fix the engine/wiring from the engine fire I had in June 2012 & had pulled everything. Now I'm putting the car back together but I don't have any good pics & can't tell. There are two lines from the heater core. Both go to the water pump, and one has a small line that crosses over the valve cover. Where does that go to & does anyone have pics? The set up on my 77 is completely different so I can't reference it.
-
Don't know about the 80 but on my 74 the one that crossed over the valve cover went to the choke housing.
-
Yeah it's similar on the 77 but it changed. The pics from 2012 are inconclusive as to where they go.
-
they had two ways , first one ran like to photo, over the valve cover to the choke housing and then to the intake , later one went to elelctric choke , the hose ran from the water pump and back to a extra
tube on the thermostate housing ,
-
Below are a couple 1980 Pinto photos from ebay, I believe. That little hose crossing over the valve cover appears to go to the intake manifold, outside lower rear area of the manifold water plate.
-
I have an 79, care the lines the same? i can take some pictures if you still need em
-
I have an 79, care the lines the same? i can take some pictures if you still need em
If there is a small line that goes across the back of the valve cover it is the same & that would be greatly appreciated. It's much smaller than the 5/8 heater hose that goes to the water pump & thermostat housing.
I found some old pics of the car but still inconclusive & looks like I might be missing a metal line but not sure.