Current Classifieds

Clutch Cable Needed
Date: 04/03/2017 11:03 pm
Rare parts for sale
Date: 09/10/2018 08:38 am
1976 Pinto runabout

Date: 03/28/2017 08:14 pm
1972 Rallye wagon rebuild
Date: 11/14/2020 07:31 pm
Wheel cap
Date: 04/25/2022 11:21 pm
1975 rear end, 8 inch, drum brakes, and axles, 3.4 gear.

Date: 11/08/2019 10:01 am
72 Runabout for Sale- Washington

Date: 02/28/2024 02:07 pm
76 pinto sedan sbc/bbc project for sale $1700 obo

Date: 10/27/2018 03:30 pm
FLOOR PANS
Date: 06/12/2020 07:24 pm
Need '75 Pinto wagon front seat belt assembly housing
Date: 10/03/2018 10:46 pm
1976 Ford Pinto Pony
Date: 09/06/2018 05:40 pm
72 pinto drag car

Date: 06/22/2017 07:19 am

« previous next »
Pages: [1]   Go Down

Author Topic: 1977 V6 drive shaft color codes  (Read 1235 times)

0 Members and 1 Guest are viewing this topic.

Offline DBSS1234

  • Pinto Full Member
  • ***
  • Posts: 247
  • FeedBack: +29/-0
  • Gender: Male
  • Original owner 77 CW

    • Total Badges: 6
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter Windows User Fifth year Anniversary
1977 V6 drive shaft color codes
« on: December 11, 2013, 03:06:45 PM »
Those of you that have seen my posts of the restoration of my crusing wagon know I am trying to replicate the factory right down to the correct markings and color codes. Ford used a color code on their driveshafts to aid the assembly line workers. My drive shaft was too heavily corroded to find the stripes. Can any 1977 V6 Pinto wagon owners out there check for painted stripes on their drive shafts? I would need dimensions of the stripe widths, locations, and colors. Pictures would help too.
 
Thanks!
Logged

Offline DBSS1234

  • Pinto Full Member
  • ***
  • Posts: 247
  • FeedBack: +29/-0
  • Gender: Male
  • Original owner 77 CW

    • Total Badges: 6
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter Windows User Fifth year Anniversary
Re: 1977 V6 drive shaft color codes
« Reply #1 on: December 11, 2013, 03:46:02 PM »
Looking at my build sheet it appears the stripe colors will be blue, green, green, green. With this info I should only need the stripe dimensions, a drive shaft from a 4 cylinder Pinto should work as I doubt the dimensions and location of the stripes would change only the colors.
 
Thanks again.
Logged
Pages: [1]   Go Up
« previous next »