Current Classifieds

WANTED: Skinny Rear Bumper w/o guards for '71 or '72 Pinto Coupe
Date: 04/24/2018 11:45 am
1975 rear end, 8 inch, drum brakes, and axles, 3.4 gear.

Date: 11/08/2019 10:01 am
Chilton's Repair & Tune-up Guide 1971-1979 Pinto and Bobcat

Date: 03/06/2017 01:24 am
Weather Strip, Muffler, Splash Shields

Date: 02/21/2022 11:11 pm
C-3 automatic transmission

Date: 08/17/2022 10:18 am
Hatch needed
Date: 09/10/2017 09:16 pm
Offenhauser 6114 dp
Date: 09/12/2017 10:26 pm
Pinto Parts for sale
Date: 06/19/2017 02:01 pm
Ignition switch 72 pinto wagon 2.0 4 sp
Date: 12/31/2017 09:03 pm
1971 2.0 valve cover
Date: 01/25/2019 07:09 pm
Pinto Vinyl Top

Date: 10/09/2020 10:29 pm
2.3 pinto carb
Date: 08/18/2018 02:07 pm

 



2.3 bellhousing stick

Description: I have a very sick 4-cylinder pinto race car right now.  I have been chewing up flywheels and starters. if you actually look at my bellhousing there has been at least four places where it has been aluminum welded. One spot not far from the starter. The bill that is in it as a part number of D52A-6394-A-A. Looking for suggestions or a replacement!

Email Sealer63@cs.com
Phone Number 8022234233
Where are you located? Vt
Listing Date: 07/24/2019 06:50 pm
Time Left: 0 days 0 hours 0 minutes 0 seconds

Share

Member name: 7vt
Offline Offline
Member since: July 24, 2019, 06:14:18 PM

Send a message to seller
Show member's listings
0 Members and 1 Guest are viewing this listing.

Comments (1)

pintob
Pinto Member
**

FeedBack: +1/-0
Offline Offline

Gender: Male
Posts: 23

Another Pinto Owner


View Profile
August 29, 2019, 02:16:05 PM
I have 3 bellhousings where is that number located?


Powered by SMF Classifieds