Current Classifieds

Needed- Good 71-73 Rear End or parts- close to AL
Date: 09/15/2019 12:38 pm
parting out 1975 & 80 pintos
Date: 10/31/2018 12:00 pm
Wiring diagram Ignition switch 72 2.0 4 speed pinto wagon
Date: 12/31/2017 11:14 pm
76 drivers fender
Date: 07/20/2018 08:24 pm
1971 Pinto instrument cluster clear bezel WTB
Date: 03/16/2017 10:00 pm
1980 Pinto w/ Trunk
Date: 08/10/2022 04:09 pm
74 4 spd and rear axle
Date: 09/26/2018 03:51 pm
71,72 Pinto Door Panels

Date: 06/17/2018 08:27 pm
Pinto Watch

Date: 06/22/2019 07:12 pm
Pinto interior parts for Cruisen / Rallye wagon
Date: 01/19/2021 03:56 pm
1978 need kick panels and rear hatch struts and upper and lower mounts
Date: 11/29/2018 10:26 am
Many Parts Listed Below
Date: 04/20/2018 11:15 am

 



2.3 bellhousing stick

Description: I have a very sick 4-cylinder pinto race car right now.  I have been chewing up flywheels and starters. if you actually look at my bellhousing there has been at least four places where it has been aluminum welded. One spot not far from the starter. The bill that is in it as a part number of D52A-6394-A-A. Looking for suggestions or a replacement!

Email Sealer63@cs.com
Phone Number 8022234233
Where are you located? Vt
Listing Date: 07/24/2019 06:50 pm
Time Left: 0 days 0 hours 0 minutes 0 seconds

Share

Member name: 7vt
Offline Offline
Member since: July 24, 2019, 06:14:18 PM

Send a message to seller
Show member's listings
0 Members and 1 Guest are viewing this listing.

Comments (1)

pintob
Pinto Member
**

FeedBack: +1/-0
Offline Offline

Gender: Male
Posts: 23

Another Pinto Owner


View Profile
August 29, 2019, 02:16:05 PM
I have 3 bellhousings where is that number located?


Powered by SMF Classifieds