Current Classifieds

parting out 1975 & 80 pintos
Date: 10/31/2018 12:00 pm
1.6 New Ford cylinder head with side draft carbs

Date: 06/12/2018 08:18 pm
1973 Pinto Runabout

Date: 03/25/2019 09:02 pm
1970-1973 British 4 Speed Manual; Parts or Whole
Date: 03/17/2019 03:57 am
76 station wagon parts needed.
Date: 03/14/2020 01:52 pm
72 Runabout Sprint Edition

Date: 04/25/2018 02:51 pm
hood for a 79-80
Date: 11/30/2018 10:55 pm
SVO SWAP
Date: 03/15/2018 03:12 am
1980 cruising wagon ralley

Date: 07/12/2019 01:41 pm
1978 hatch back

Date: 11/29/2019 03:18 pm
Clutch Cable Needed
Date: 04/03/2017 11:03 pm
Need hatchback fuel tank sending unit
Date: 08/13/2018 02:46 pm

Author Topic: Pinto won't rev , what should I do next?  (Read 900 times)

0 Members and 1 Guest are viewing this topic.

Offline sethvincent

  • Pinto Member
  • **
  • Posts: 12
  • FeedBack: +0/-0

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Tenth year Anniversary Windows User Fifth year Anniversary
Pinto won't rev , what should I do next?
« on: October 27, 2015, 01:51:24 AM »
I have a 78 that I've had a lot of problems with in the last couple months.  I'm going to list all the problems in case they are related.
The engine seemed to run hot, and after driving for a while, if you shut it down and didn't wait for it to cool down, it would start back up but would die within a minute and then it wouldn't start again until it sat for an hour or so.  When this happened I would get no fuel to the carb.  I couldn't get a mechanical pump right away so I threw in an electric pump that had similar specs to the factory pump.
 After changing the pump, I drove the car for a while, let is sit for about 10 minutes, tried to restart it and it wouldn't. Ran the battery down trying to start it.  Couple hours later, jump started it, drove home with no trouble.  Next time I went to drive it, battery was dead.  Put a new battery in, drove it about a half hour no problems. Couple hours later, drove home, again, no problem.
  Sat for two weeks, was really hard to start and when it finally did start, it wouldn't accelerate.
So, I replaced distributor cap, rotor, plugs, plug wires, timing belt and rebuilt the carb.  It stars very easily, but still doesn't accelerate.  I wanted to see if the advance was working and tried to rev it while using the timing light and noticed that when I tried to rev the engine, the light would go off, then come back on after I backed out of the throttle.
   Is this an ignition module issue?  coil?  distributor? something else entirely?