Topic: Manual transmission outputshaft size??

[sponge003]

Hi,

Building a road racer for lemons racing and have put a 8.8 rear end in it out of a Turbo Tbird. I am going to run the 4 speed manual and am having a hell of a time finding out what output spline size is so I can investigate the driveshaft options.

I know some people have used an aluminum rear driveshaft from a 97 4wd Aerostar van but I don't know what the splines are to make sure it can work.

I can probably use the stock driveshaft and get a flange yoke for the 8.8 and a crossover U-joint and make it work.

Appreciate the help

Paul

[82expghost]

i cut down a foxbody manual tranny 8.8 driveshaft, and it fit in my t9, and the t9 is the same as pinto 4 speed, if any help

[amc49]

The C3 output is the same as well, at least on a '80 model with MTX.