Current Classifieds

Mallory Unilight dist 2.0
Date: 10/25/2019 03:44 pm
WTB: 2.0 Mech tach drive distributor
Date: 04/14/2023 06:15 am
Clutch Pedals for 75to 80 Pinto
Date: 09/21/2018 11:35 am
1974 Pinto Passenger side door glass and door parts

Date: 02/18/2017 05:55 pm
77 pinto
Date: 08/22/2017 06:31 pm
1974 Pinto Misc. moldings & parts

Date: 12/20/2016 10:47 pm
Built and Injected early 2000cc Engine

Date: 04/10/2017 07:30 pm
Clutch Cable Needed
Date: 04/03/2017 10:54 pm
Right side strut mount for 3rd door 1979 runabout
Date: 10/04/2019 08:43 pm
76 pinto sedan sbc/bbc project for sale $1700 obo

Date: 03/27/2017 10:07 pm
1971 Pinto Do It Yourself Manual

Date: 03/06/2017 01:19 am
Squire trim
Date: 03/28/2018 10:11 am

Author Topic: Pinto won't rev , what should I do next?  (Read 891 times)

0 Members and 1 Guest are viewing this topic.

Offline sethvincent

  • Pinto Member
  • **
  • Posts: 12
  • FeedBack: +0/-0

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Tenth year Anniversary Windows User Fifth year Anniversary
Pinto won't rev , what should I do next?
« on: October 27, 2015, 01:51:24 AM »
I have a 78 that I've had a lot of problems with in the last couple months.  I'm going to list all the problems in case they are related.
The engine seemed to run hot, and after driving for a while, if you shut it down and didn't wait for it to cool down, it would start back up but would die within a minute and then it wouldn't start again until it sat for an hour or so.  When this happened I would get no fuel to the carb.  I couldn't get a mechanical pump right away so I threw in an electric pump that had similar specs to the factory pump.
 After changing the pump, I drove the car for a while, let is sit for about 10 minutes, tried to restart it and it wouldn't. Ran the battery down trying to start it.  Couple hours later, jump started it, drove home with no trouble.  Next time I went to drive it, battery was dead.  Put a new battery in, drove it about a half hour no problems. Couple hours later, drove home, again, no problem.
  Sat for two weeks, was really hard to start and when it finally did start, it wouldn't accelerate.
So, I replaced distributor cap, rotor, plugs, plug wires, timing belt and rebuilt the carb.  It stars very easily, but still doesn't accelerate.  I wanted to see if the advance was working and tried to rev it while using the timing light and noticed that when I tried to rev the engine, the light would go off, then come back on after I backed out of the throttle.
   Is this an ignition module issue?  coil?  distributor? something else entirely?